Epson LQ-570e - Page 115

EPSON LQ-570e/LQ-580 Revision C
Appendix EEPROM Address Map
1
15
4AH Panel mask pattern 1 b0:LOAD/EJECT function
b1:LF/FF function
b2:TEAR OFF/BIN Function
b3:Micro Adjust function
b4:(reserved)
b5:(reserved)
b6:(reserved)
b7:(reserved)
00H 00H
4BH Panel mask pattern 2 b0:Font Selection
b1:Condenced Selection
b2:Pause function
b3:Reset function
b4:(reserved)
b5:(reserved)
b6:(reserved)
b7:(reserved)
00H 00H
4CH Manual feed wait time 3 to 30 (by 0.1 sec.), 00H : 1.5 sec.(same as default) 00H (1.5 sec.) 00H (1.5 sec.)
4DH Tear-off wait time 3 to 30 (by 0.1 sec.), 00H : 3 sec.(same as default) 00H (3 sec.) 00H (3 sec.)
4EH,4FH (reserved) 0000H 0000H
50H I/F mode selection 0:Auto I/F selection
1:Parallel I/F
2:Type-B I/F
00H(Auto) 00H(Auto)
51H Auto I/F wait time setting 10:10 sec.
30:30 sec.
00:10 sec.(same as default)
00H(10 sec.) 00H(10 sec.)
52H Input Buffer 0: On(64Kbyte)
1: Off(1 byte)
00H(On) 00H(On)
53H IEEE1284.4 for Parallel I/F 0:Auto
1: On
2: Off
00H(Auto) 00H(Auto)
54H (reserved) 00H 00H
55H Parallel I/F bidirectional mode b0:Parallel I/F bidirectional mode 0:On 1:Off
b1-b7: (reserved)
00H 00H
Table 7-15. EEPROM Address Map
Address Data Data Format Q-pit data Factory Setting