Epson LX-810 Technical Manual

REV.-A
NOTES FOR REASSEMBLY:
The following applies to E-ring reattachment:
● When attaching a ring to the left pulley shaft, set it so that its opening faces
left.
● When attaching a ring to the right pulley shaft, set it so that its opening faces right.
O Use tweezers to check that the attached retaining rings are firmly in place and will not not move.
4-23

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)