REV.-A
1.8.3 Buzzer Operation
The buzzer sounds under the following conditions:
BEL
code:
The buzzer sounds for 0.1 second when a
BEL code is input.
Carriage trouble:
Beeps 6 times, pausing briefly after 3rd beep.
Paper-out:
Beeps 20 times, pausing briefly after every 4 beeps.
Abnormal voltage:
Beeps 5 times, pausing after every beep.
Incorrect RAM:
(SRAM) Beeps 8 times, pausing briefly after every 2 beeps. (Inside CPU)
Beeps indefinitely until
power OFF.
Recognition of panel operation:
Beeps 1 or 2 or 3 times in setting print mode.
Factory setting:
Beeps once when the value under micro-adjusting is equal to the
factory-set value.
Sheet ejection failure (in CSF mode):
Beeps 20 times, pausing briefly after every 4 beeps.
Illegal paper
releaselunrelease:
Beeps continuously when the paper release lever is changed when the
.-
.*
$,”.
paper is in the paper path. Beeps until the lever is changed again or the
paper is completely out of the path.
1-20
To Next Page
Loading...
