Epson LX-810 Technical Manual

REV.-A
1.7 TEAR-OFF
The Tear-Off function
FUNCTION
can be enabled by making the appropriate DIP switch setting, and will operate
when the release-lever is set to the tractor position. In such a case,
if the input data buffer is empty
and the printer is
ON-LINIE, the paper will automatically be fed to the tear-off position, and the ON-LINE
LED will flash to indicate that the FORM FEED and LINE FEED switches are now available to perform
micro-adjustment. The user may then adjust the paper to the tear-off position. This position becomes
the new tear-off position default, and will remain valid even if the printer is reset and reinitialized, and
regardless of whether the main power has been interrupted. When new data are input to the printer,
the paper will automatically be returned to its original position, and printing will then start. Paper having
been advanced to the tear-off position will also be returned to its original position if the ON-LINE switch
is pressed (switching the printer from ON-LINE to OFF-LINE).
1-17

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)