Epson LX-810

1.4 DIP SWITCH AND JUNIPER SETTINGS
This section describes DIP switch settings for the LX-8 10/850 printer.
1.4.1 DIP Switch Settings
The two DIP switches are located on the side of the printer and function as shown in Tables 1-13 through
1-15. Note that the status of the DIP
switc:hes is read only at power on or upon receipt of the I NIT signal.
Table 1-13. Settings for D!P Switch 1 (SW1)
No.
Description
ON
OFF
Fectory Setting
1 I Character Pitch
I
12 cpi
I
10 cpi
I
OFF
2
Shape of Zero
0
0
OFF
3
Table Selection (note)
Graphics
Italics
OFF
4 I Tear Off
I
Invalid
I
Valid
I
OFF
E
‘ ‘ “gh
:’
Normal
See Table 1-15
When the DIP switch is set for the Italic table, at power on printer defaults to ESC 7 table. When
the switch is set for the Graphic table, at power on it defaults to
ESC 6 table.
Table 1-14. Settings for DIP Switch 2 (SW2)
No.
Description
ON
OFF
Factory Setting
.-
1 Page length
12 in.
11 in.
OFF
2
Cut-Sheet Feeder (CSF) Mode
On
off OFF
3
l-inch skip On
off
OFF
4 AUTO FEED XT Signal Internally Fixed or
~t
Fixed to LOW
Depends On
Ex- OFF
ternal Signal
Table 1-15. International Character Set Selection
1-6 1-7 1-8 Country 1-6 1-7
1-8
Country
On I On I On
U.S.A Off ] On I On
Denmark 1
1.4.2 Jumper Setting
Jumper 1 (user-selectable) is located on the TAMA board. If the jumper is connected, the SLCT-IN signal
is fixed to LOW, and DC 1 /DC3 printer select control is ignored.
1-15