REV.-A
Table 6-2. Lubrication Points (Refer to Figure 6-2)
Ref. No. Lubrication Points
Lubricant
(1)
Shaft which sets paper feed reduction
G-26
(2)
Contact portion of sub paper
re!ease
lever and paper release lever,
G-26
(3)
Oil pad
o-2
(4)
Carriage guide shaft (at both left and right sides of carriage) G-26
(5)
Carriage guide plate (the portion that contact the carriage) G-26
(6)
Platen gear G-26
(7)
Belt pulley gear
G-26
(8)
Ribbon transmission gear G-26
(9)
Paper tension roller shaft
G-26
(lo) Gear portion of the ribbon gear G-26
(11)
Shaft which sets the ribbon gears
G-26
(12) Paper feed roller shaft G-37
(13)
Contact portion of tractor frame L and tractor shaft. G-26
(14) Contact portion of
GND spring and platen shaft G-20
NOTE: Lubrication is necessary when assembling.
Table 6-3. Adhesive Application Point (Refer to Figure 6-1.)
Adhesive Application Point
No. of Points
Where the timing belt engages the carriage.
1
<To Timing Belt>
Figure 6-1. Correct Adhesive Application
6-2
To Next Page
Loading...
