Epson LX-810

Enhancing Your Printing
You can choose between the draft and NLQ fonts with either
software commands or the SelecType feature. However, high-speed
draft printing can only be selected by setting DIP switch 1-5 (see
the section on setting the DIP switches in Chapter 3).
Note: High-speed draft printing is only available when 10 cpi
printing is selected. The only print enhancements that can be
combined with high-speed draft printing are underline mode and
double-wide mode. If other enhancements or character sizes are
selected, high-speed draft is ignored and replaced by normal
draft.
Character spacing
To add greater variety to your documents, the printer has two
types of character spacing, 10 and 12 cpi (characters per inch). Each
is selected with a software command or a DIP switch (see the
section on setting the DIP switches in Chapter 3). The printout
below compares the two types.
This is 10 cpi printing.
This is 12 cpi printing.
Note: High-speed draft printing is available only in 10 cpi. If
you select 12 cpi, the print speed temporarily switches to normal
draft speed until 12 cpi is turned off.
Software and Graphics 4-3