Epson LX-810 User Manual

Options
Problem
Solution
Using the cut sheet
feeder, paper does
not feed properly.
When the
LOAD/EJECT button
is pressed, the
platen does not
rotate and paper
does not feed.
j\fter a print
command is sent
from the computer,
the platen does not
rotate and the paper
does not feed.
When a print
command is sent
from the computer,
the platen rotates
hut paper does not
feed.
You may be trying to feed paper while the
printer is on line. Always put the printer
off line before feeding paper. Paper feeds
automatically when the cut sheet feeder
receives a print command from the
computer (only while the printer is on
line). Refer to 5-12.
The printer may be off line. Press the ON
LINE button to put the printer on line.
Refer to 3-3.
The cut sheet feeder (CSF) mode may be
off. Set DIP switch 2-2 to ON. If your
program allows you to use control codes,
use ESC EM4 to set the CSF mode. Refer
to 5-5, 9-11.
DIP switch 2-2 may be set to OFF. DIP
switch 2-2 must be set to ON in order to
use the cut sheet feeder. Refer to 3-7, 5-5.
The cut sheet feeder may be incorrectly
installed on the printer. Remove and
reinstall the cut sheet feeder, making sure
that the mounting notches are properly
mated with the pins on the printer. Refer
to 5-2.
7-22 Troubleshooting

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)