Epson LX-810

Options
Problem
Solution
The cut sheet feeder may be out of paper.
Load more paper in the cut sheet feeder's
bin. Refer to 5-7.
The paper release lever may be forward to
the continuous paper position. Push the
lever back to the single sheet position.
Refer to 5-3.
The paper set levers may be pulled
forward. After loading a stack of paper
into the cut sheet feeder, push the paper
set levers backward. Refer to 5-8.
The left and right paper guides may be too
close together, preventing smooth paper
feeding. Adjust the position of the paper
guides so that the paper can move up and
down freely. Refer to 5-8.
Paper may be jammed near the print head.
Remove the jammed paper (temporarily
remove the cut sheet feeder if necessary).
You may have loaded too many sheets in
the cut sheet feeder's bin. Remove some of
the sheets. Refer to 8-13.
There may be only one sheet left in the
bin. (The last sheet in the bin usually does
not feed.) Add more paper. Refer to 5-7.
Troubleshooting 7-23