Epson LX-810 User Manual

Options
Problem
Solution
Using the cut sheet
feeder (continued).
Two or more sheets
feed at the same
time.
The paper feed is
crooked.
You may have loaded too many sheets in
the cut sheet feeder's bin. Remove some of
the sheets. Refer to 8-13.
You may have forgotten to fan the stack
of paper before loading it into the bin.
Remove the paper and fan it. Then align
the edges of the stack. Refer to 5-7.
The paper may be old or creased. Use only
new, clean sheets of paper.
The left and right paper guides may be too
far apart. Adjust the paper guides to the
width of the paper. Refer to 5-8.
There may be too much paper in the
stacker. Never let more than 80 sheets of
paper accumulate in the stacker. Refer to
8-13.
The weight of your paper may be too
heavy or too light for the cut sheet feeder.
Refer to the specifications on page 8-14
and make sure that your paper is the
proper size and quality.
7-24 Troubleshooting

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)