Epson LX-810

Cut Sheet Feeder
3. Slide the left paper guide to where the fin on the edge guide
aligns with the arrow on the front panel. Next, slide the right
paper guide to roughly match the width of your paper.
4. Take a stack of paper and fan it as shown. This keeps the
paper from sticking so that only one sheet feeds at a time. Tap
the side and bottom of the paper on a flat surface to even up
the stack.
Note: For best results, use typewriter quality paper. If you plan
to use paper with a glossy or textured surface, you should test it
before regular use. Do not use multi-part forms, carbon paper,
envelopes, or labels in the cut sheet feeder.
Using the Printer Options 5-7