Epson LX-810 User Manual

Choosing a Place for Ike Printer
The stand should be able to support at least twice the weight
of the LX-810 printer (11.5 kg approx).
Never use a stand that tilts the printer at an angle of more
than 15 degrees from horizontal.
Note: If you plan to use a printer stand, read through the list of
requirements and suggestions below to ensure that you have the
right stand for your printer.
With a cut sheet feeder installed, your printer should be kept
level at all time. ^
If your paper supply is positioned below the printer stand,
make sure that there is enough clearance to keep the paper
from catching on the underside of the stand. Also, check to
see that the distance between the stand supports is wide
enough to accommodate the paper you will be using.
Position your printer's power cable and 1/F cable so that
they do not interfere with paper feeding. If possible, secure
the cables to the printer stand support.
1-6 Setting Up the Printer

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)