Epson LX-810 User Manual

Paper Handling
Problem
Solution
Continuous paper
does not feed
properly (continued).
When the
LOAD/EJECT button
is pressed to eject
the paper, the paper
does not fully eject
or it jams.
Switching between
continuous paper
and single sheets
cannot be performed
properly.
When the
LOAD/EJECT button
is pressed to load a
single sheet from the
paper guide, the
platen rotates in
reverse, the single
sheet does not load,
and the continuous
paper comes off the
sprockets.
You may have tried to reverse-feed too
many pages. Before ejecting the paper,
always tear off the last printed page.
Refer to 2-15.
You may be trying to eject labels. Labels
jam when they are fed backward, so
always use the FORM FEED button to eject
labels. Refer to 2-26.
Push the paper release lever back to the
single sheet position, reattach the
continuous paper, then press the
LOAD/EJECT button.
7-20 Troubleshooting

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)