Epson LX-810 User Manual

Options
Problem
Solution
Skip over perforaHon
is set, but the skip
has shifted from the
perforation, or the
perforation does not
fall in the center of
the skip.
When the printing
ends, the paper feeds
abruptly, and as it
resumes printing,
the paper feeds
backward and comes
off the pull tractor
sprockets.
When the
LOAD/EJECT button
is pressed to eject
the paper, the paper
comes off the pull
tractor sprockets.
The page length for one page of the
continuous paper may be set incorrectly.
Set DIP switch 2-1 or use control codes
ESC C or ESC C 0 to set the correct page
length. Refer to 3-10, or 9-13.
The loading position of the paper may be
too high or too low. Use the micro-
adjustment feature to reset the loading
position. Refer to 3-12.
The short tear-off function may be
selected. The short tear-off function
cannot be used with the pull tractor, so be
sure to set DIP switch 1-4 to ON.
When the paper release lever is in the
continuous paper position, the paper feeds
backward to eject. When using the pull
tractor, press the FORM FEED button to
feed the paper forward.
Troubleshooting 7-29

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)