Epson LX-810 - Page 280

Commands A^rranged by Topic ^
BSC 6 Printable Code Area Expansion
Format:
ASCII code: ESC 6
Decimal: 27 54 ^
Hexadecimal: IB 36
ESC 7 Enable Upper Control Codes
Format:
User-defined characters
ESC & Define User-defined Characters (draft mode)
Format:
Comments:
Enables the printing of codes 128 through 159 (decimal) as
characters, not control codes. This allows the use of these
characters for user-defined characters. See the Appendix for
characters printed. This is the default if DIP switch 1-3 is OFF
(set for italic character set). ^
ASCII code: ESC 7
Decimal: 27 55 ^
Hexadecimal: IB 37
Comments:
This code caused codes 128 through 159 to be treated as control
codes. This is default if DIP switch 1-3 is ON (set for graphic
character set).
ASCII code: ESC & 0 nl n2 al dl d2 dn
Decimal: 27 38 0 nl n2 al dl d2 dn
Hexadecimal: IB 26 00 nl n2 al dl d2 dn
Comments:
This command allows characters to be redefined in the draft
mode. The variables nl and n2 must be between 58 and 63 (3A
through 3F hex).
9-32 Command Summary ^