Epson LX-810

Character Tables
Note; Depending on the setting of DIP switch 1-3, the characters
in the shaded areas are treated as control codes, the same control
codes found in the range 0 to 31 and 127, or can be printed as
shown in the tables above. The status can be changed by sending
an ESC command to the printer, as described in the following
table:
DIP switch 1-3
setting
Power-on default
status
ESC command to
reverse status
OFF (italic
character table)
Shaded characters
treated as control
codes
ESC 7
ON (graphic
character table)
Shaded characters
can be printed as
shown
ESC 6
A-4 Appendix