Epson LX-810 User Manual

FCC COMPLIANCE STATEMENT FOR AMERICAN USERS
This equipment generates and uses radio frequency energy and if not installed and used
properly, that is, in strict accordance with the manufacturer's instructions, may cause ^
interference to radio and television reception. It has been type tested and found to comply
with the limits for a Class B computing device in accordance with the specifications in
Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection
against such interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
interference to radio and television reception, which can be determined by turning the ^
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient the receiving antenna
• Relocate the printer with respect to the receiver
• Move the printer away from the receiver ^
• Plug the printer into a different outlet so that the printer and receiver are on different
branch circuits. ^
If necessary, the user should consult the dealer or an experienced radio/television technician
for additional suggestions. The user may find the following booklet prepared by the Federal
Communications Commission helpful:
"Television Interference Handbook"
This booklet is available from the U.S. Government Printing Office, Washington DC 20402.
Stock No. 004-000-00450-7.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will
invalidate the FCC Certification of this device and may cause interference levels that exceed ^
the limits established by the FCC for this equipment. If this equipment has more than one
interface connector, do not leave cables connected to unused interfaces. ^
All rights reserved. No part of this publication may be reproduced, stored in a retrieval
system, or transmitted, in any form or by any means, mechanical, photocopying, recording,
or otherwise, without the prior written permission of Epson America, Inc. No patent liability
is assumed with respect to the use of the information contained herein. While every
precaution has been taken in the preparation of this book, Epson America, Inc. assumes no ^
responsibility for errors or omissions. Neither is any liability assumed for damages resulting
from the use of the information contained herein.
Epson America, Inc. shall not be liable against any damages or problems arising from the use
of any options or any consumable products other than those designated as Original Epson
Products or Epson Approved Products by Seiko Epson Corporation.
Graphics created with UniPaint by Unison World Inc. and EPSON 3D-Graph.
Epson and Epson ESC/P are registered trademarks of Seiko Epson Corporation. ^
IBM is a registered trademark of International Business Machines Corporation.
SmartPark is a trademark of Epson America, Inc. ^
Copyright © 1989 by Epson America, Inc. ^
Torrance, California
ii ■

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)