Epson LX-810 User Manual

Selecting Tjrpestyles
You can produce a wide rcinge of typestyles by combining different
fonts, widths, and other print variations. You can select typestyles
in three different ways: by using the SelecType feature on your
control panel, by changing the DIP switches, or by using software
commands. This section describes only how to select typestyles
with the SelecType feature. DIP switch settings are described
earlier in this chapter. Software commands are described in
Chapter 9.
You can use the control panel to choose fonts and condensed
printing. The number of beeps you hear indicates which features
you are choosing. The ON LINE light must be lit before you can use
the SelecType feature.
SelecType is not available when the ON LINE light is blinking. If
the ON LINE light is blinking, first press the ON LINE button.
Buttons
DRAFTJ
(D)
'sans seme JJJ
(O
CX)N- ON j
DENSEDoffJJ
O)
Number of beeps
Typestyles
Select draft font
Select NLQ Roman font
Select NLQ Sans Serif font
Select Condensed mode
Cancel Condensed mode
Using the Printer 3-19

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)