Epson LX-810 User Manual

Choosing a Character Table
To select a character table, set DIP switch 1-3 according to the
table below.
Character table
DIP SW 1-3
Italics
OFF
Graphics
ON
0
CAUTION: To change the setting of a DIP switch, first
turn off the printer, change the DIP switch, and then
turn the printer back on.
Tables showing what characters are printed in each of the character
tables are listed in the Appendix.
3-26 Using the Printer

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)