Fine-tuning the Projector 65
■ Lamp Hours
Displays the number of hours the lamp has been used. The
life span of the lamp ranges from about 3000 hours in
High
brightness mode to about 4000 hours in
Low brightness
mode. If the number shown is close to 3000 or the
information is displayed in red, make sure you have a spare
lamp handy.
■ Source
Displays the input source currently being projected.
■ Input Signal (computer, RGB video, and component video)
Displays the input signal setting.
■ Resolution (computer, RGB video, and component video)
Displays the input resolution.
■ Video Signal (composite and S-Video)
Displays the video signal format.
■ Refresh Rate (computer, RGB video, and component video)
Displays the refresh rate.
■ Sync Info (computer, RGB video, and component video)
Provides information that may be needed by the service
technician.
■ Status
Displays informations about projector problems. This
information may be needed if service is required.
3. When you’re finished, press
Esc or Menu.
note
The lamp usage timer
doesn’t register until you’ve
used the lamp for at least
10 hours.
To Next Page
Loading...
Need help?
General