Using the Projector on a Network 77
5. Press the Menu button on the remote control, select the
Network menu, then press Enter.
6. Choose
Network Configuration and press Enter.
7. Select the
Wired LAN menu and press Enter.
8. Choose
IP Settings and press Enter. You see a screen like the
following:
9. Do one of the following:
■ If your network assigns addresses automatically, turn on the
DHCP setting.
■ If your network does not assign addresses automatically, turn
off
DHCP and enter the projector’s IP Address, Subnet
Mask
, and Gateway Address, as needed.
To Next Page
Loading...
