135
B
Notices
This appendix includes safety instructions and other important information
about your projector.
Important Safety Instructions
Follow these safety instructions when setting up and using the projector:
■ Do not look into the lens when the projector is on. The bright light can
damage your eyes.
■ Do not place the projector on an unstable cart, stand, or table.
■ Do not operate the projector on its side, or while tilted to one side.
Do not tilt the projector forward or back at a greater angle than that
specified for keystone correction (see page 128).
■ The projector should be installed by qualified technicians using
mounting hardware designed for use with this projector.
■ If you apply adhesives to the mount to prevent the screws from
loosening, or if you use lubricants or oils on the projector, the projector
case may crack and the projector may fall from its mount. This could
cause serious injury to anyone under the mount and could damage the
projector. When installing or adjusting the mount, do not use adhesives
to prevent the screws from loosening and do not use oils or lubricants.
■ Do not stand on the projector or place heavy objects on it.
■ Do not use the projector where it may be exposed to rain, water, or
excessive humidity.
■ Unplug the projector from the wall outlet before cleaning. Use a dry
cloth (or, for stubborn dirt or stains, a moist cloth that has been wrung
dry) for cleaning. Do not use liquid or aerosol cleaners.
■ Never spill liquid of any kind into the projector.
■ Do not use the projector where it may be exposed to excessive dust or
smoke.
■ Never push objects of any kind through the cabinet slots.
To Next Page
Loading...
Need help?
General