Control panel
A
P light (power light)
The printer's operational status is indicated by a lit or flashing light.
On : The power is on.
Flashing : The printer is operating such as receiving data, shutting down, or performing Print Head
Cleaning.
Off : The power is off.
B
P button (power button)
Turns the power on and off.
C [ ] button (rewind button)
Depending on the status of the media loading lever, operations differ as shown below.
❏ When the media loading lever is moved to the front
You can rewind the media by holding down the button. Rewinding stops when the leading edge of the media reaches
the print start position. Rewind can be resumed by releasing the button and then pressing it again. Press and hold the
button to speed up the rewinding. This is useful when fine-tuning media alignment as you can rewind the media in
increments of 0.4 mm by pressing the button briefly.
❏ When the media loading lever is moved to the back
You can rewind media that has been loaded with the printable side out by holding down the button.
D [ ] button (feed button)
SC-R5000 Series/SC-R5000L Series User's Guide
Introduction
16
To Next Page
Loading...
Need help?
General
