Epson Stylus CX7300 - Page 115

EPSON Stylus CX7300/CX7400/DX7400/NX200/TX200 series/SX200 series/Stylus CX8300/CX8400/DX8400/NX400/TX400 series/SX400 series Revision C
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 115
Confidential
4. Remove the screw (x1) that secures the Front Frame and the Right Frame
together.
5. Release the dowel (x1) and the hook (x1) that secure the Right Frame, and
remove the Right Frame.
Figure 4-49. Removing the Front Frame/Right Frame (2)
6. Release the hook (x1), and remove the Front Frame.
Figure 4-50. Removing the Front Frame/Right Frame (3)
C.B.P. 3x6, F/Zn-3C (6±1kgfcm)
Hook
dowel
Right Frame
Front Frame
Cutout
Hook
 After replacing the Front Frame, be sure to attach an acetate
tape referring to the figure below.
Figure 4-51. Acetate Tape Position
 When installing the Front Frame, pay attention to the
following instructions.
• As shown in Figure 4-50, be sure to secure the Front Frame
with the hook (x1) and the cutouts (x2).
• As shown in Figure 4-49secure the Front Frame and Right
Frame together with the screw. (Place the Right Frame on
top of the Front Frame.)
 Secure the Head FFCs (x3) to the Front Frame with the
acetate tape (x1) as shown in the figure below.
Figure 4-52. Acetate Tape Position
10mm
18mm
Acetate Tape (40mm)
Bending Point of Head FFC
Align the edge of the Front
Frame with the bending
point of the Head FFC, and
secure the FFC with the
acetate tape.