Loading and Cutting Roll
Paper
Loading Roll Paper
Using the supplied roll paper holder, position the paper
at the rear of the printer.
A
Turn on the printer.
B
Open the output tray.
Do not pull out the tray extension.
C
After confirming that the end of the roll paper is
cut straight across, insert the supplied roll paper
holder into the ends of the roll.
If the end of the roll paper is not cut straight
across, trim it straight before proceeding.
D
Move the roll paper edge guide at the back of the
printer all the way to the right.
E
Attach the roll paper holder to the rear of the
printer.
Align the triangles on the roll paper holder with
the triangles on the printer and insert the tabs
into the matching slots.
F
Lightly insert the roll paper into the rear roll
paper feeder and match the edge guide to the
width of the paper.
Epson Stylus Photo R2000 User's Guide
Basic Operations
23
To Next Page
Loading...
Need help?
General
Weight and Dimensions
