G
Slide the roll paper in until it stops and keep it
lightly held in this position for about three
seconds.
The paper will be fed into the printer
automatically.
Tip:
❏ Open the printer cover and look down into the
printer to check that the paper is not being fed
at a slant.
❏ To eject the roll paper from the rear of the
printer without printing, press the M button
for three seconds or more. To end the
blinking ) light error display, press the
M button again after turning the knob on the
roll paper holder to take up the excess paper.
Cutting Roll Paper
Use scissors or other cutters to cut the print results from
the roll when printing is complete.
A
Press the M button when printing is complete.
The printer will print a cut line and feed the
paper.
B
Cut the paper along the cut line.
C
Do one of the following.
To continue printing on roll paper:
Press the M button again to return the end of the
roll to the printing position.
To remove the roll paper:
Press the M button for three seconds or more to
eject the roll paper from the rear of the printer. To
end the blinking ) light error display, press the
M button again after turning the knob on the roll
paper holder to take up the excess paper.
Epson Stylus Photo R2000 User's Guide
Basic Operations
24
To Next Page
Loading...
Need help?
General
Weight and Dimensions
