Epson STYLUS PRO 4910 - Recommended Tools

Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
DISASSEMBLY & ASSEMBLY Overview 103
Confidential
3.1.4 Recommended Tools
To protect this product from damage, use the tools indicated in the following table.
For the tools required to perform the adjustment, refer to “Tools/Consumables for
Adjustments” in Chapter 4.
Table 3-1. Tools
Name Description Target Part
Phillips screwdriver, No. 1
4 cm or longer shaft length (The
one with a magnet is
recommended)
 Printhead
 Fan of SpectroProofer
 Some encoders/sensors
Phillips screwdriver, No. 2
25 cm or longer shaft length (The
one with a magnet is
recommended)
Parts in general
Stubby driver with 4 cm or shorter
shaft length (The one with a
magnet is recommended)
 CR Motor
 Some sensors
Torque driver, No2 0.39 ± 0.05N/m can be measured.
 Ink Tubes
 Ink Selector
 Cartridge Holder
Flat-blade screwdriver Nothing in particular
 Roll Unit Connector
 Main Board
Tweezers Nothing in particular Overall parts
Pencil
To mark the part installation
position
 CR Belt
 PF Belt
 Ink tube clamp
Acetate tape
To secure the cable/harness, or for
the protection against the sharp
edge
Parts in general (Use this tape
when it is removed or when
replacing the part)
Waste cloth
To prevent staining the printer
with ink during operation
 Ink Tube
 Ink Selector Assy
 Cartridge Holder
 Printhead
 IS Unit