Epson STYLUS PRO 4910 - Cutter Replacement; Removing the Cutter; Installing a New Cutter

Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 127
Confidential
3.4.1.4 Cutter Replacement
1. Remove the Front Cover. (p142)
2. Open the Cutter Cover.
3. Loosen the screw that secures the cutter, and remove the cutter.
A) Silver, Phillips, Bind P-tite M4x10: one piece
Figure 3-17. Removing the Cutter
4. Set the positioning holes of the new cutter to the bosses of the main body.
Figure 3-18. Installing a new cutter
5. Secure the cutter with the screw. See Figure 3-17.
6. Close the Cutter Cover. See Figure 3-17.
7. Set the Front Cover, and secure it with the four screws. See Figure 3-17.
C A U T I O N
When removing the cutter, be careful not to drop it.
Cutter Cover
Cutter
A
C A U T I O N
When securing the cutter in the next step, be sure to secure it
firmly. Otherwise, the cutting position may be misaligned or
skewed.
Cutter
Bosses
Positioning holes