Epson STYLUS PRO 4910 - Cleaning by Feeding Paper; Cleaning the Platen

Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
MAINTENANCE Cleaning 416
Confidential
CLEANING BY FEEDING PAPER
When dirt on some roller is attached on the printed paper, make sure to clean the soiled
roller by feeding/ejecting plain paper as follows.
1. Turn on the printer, and set the roll paper of 17-inch width.
2. Press the [Paper Feed (Forward)] button to feed the paper.
3. Repeat feeding until the paper is not soiled with ink.
CLEANING THE PLATEN
If the back of the printed paper is smeared, make sure to clean the platen as follows.
1. Turn off the printer.
2. Open the printer cover and use a soft clean cloth to clean away any dust or dirt.
If there is a serious problem of dirt, clean it using a soft, clean cloth dampened
with a mild detergent. Then, wipe the platen with a dry, soft cloth.
Figure 5-5. Cleaning the platen
C H E C K
P O I N T
Always wipe it from back to front in order not to spread the dirt.
C A U T I O N
Do not touch the feed rollers, waste ink pads (the parts marked
with gray in Figure 6-2), or ink tubes.