Epson STYLUS PRO 4910 - Borderless Printing Specification; Available Paper Type; Borderless Printing Mode

Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
PRODUCT DESCRIPTION Printing Specifications 24
Confidential
1.3.4 Borderless Printing Specification
AVAILABLE PAPER TYPE
For the paper types and sizes that support the borderless printing, see
"1.3.2.2 Designated Paper" (p18).
BORDERLESS PRINTING MODE
The following types of borderless printing are available with the printer driver.
Note "*1": The cut pages vertical length becomes about 2mm shorter than the specified size.
"*2": Color inconsistencies or ink smudges due to the interruption of printing for cutting off top
margins are likely to occur on the following papers.
• Glossy media such as PGPP250
• Single Weight Matte Paper
Table 1-4. Borderless Printing Mode
Driver Setting Printer Operation Remarks
Normal Cut*
2
Prints an image bleeding it off
the left and right edges of
paper. The top and bottom
margins are determined by
Roll Paper Margin setting.
Default
Single Cut
*
1
*
2
Prints an image bleeding it off
all the edges of paper.
The cutting methods is as
follows.
 The minimum width
required for cutting is
applied as the top margin of
the first page, then the top
margin is cut off during
printing.
 No margin is provided between pages, and the
cutting is made on the border between the pages.
 When the job is finished, the bottom side of the last
page is cut off without margin.
 The minimum width required for cutting is applied
as margins between pages.
 Printing is interrupted
for cutting off the top
margin of the first
page. This may cause
color inconsistencies
depending on the print
data.
 The cut line between
pages may be slightly
off the border.
Double Cut
*
1
*
2
Prints an image bleeding it off
all the edges of paper.
The cutting methods is as
follows.
 The auto refresh margin is
applied as the top margin of
the first page, then the top
margin is cut off during
printing.
 The bottom side of each
page is cut off without margin.
 The minimum width required for cutting is applied
as margins between pages.
 Printing is interrupted
for cutting off the top
margin of the first
page. This may cause
color inconsistencies
depending on the print
data.
 The top and bottom
sides of each page are
cut off at the position
slightly inward the
image edges so that no
white margin appears
on the edges of the cut
pages. This causes the
vertical length of the
cut page about 2mm
shorter than the
specified length.
Table 1-4. Borderless Printing Mode
Driver Setting Printer Operation Remarks