Epson STYLUS PRO 4910 - 3.4 Disassembly and Assembly Procedure

Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 125
Confidential
3.4.1.2 Roll Unit
1. Make sure the printer is off before unplugging the roll unit.
2. Disconnect the connector of the Roll Unit from the main body.
3. Remove the two screws that secure the Roll Unit.
A) Silver, Phillips, Round Washer Head S-tite M3x8: two pieces
4. Pull the Roll Unit backward, and remove the shaft of the Roll Unit from the
bearing of the main body.
5. Remove the Roll Unit.
Figure 3-14. Removing the Roll Unit
Connector
- Rear side -
A
Roll Unit
Shaft
Bearing
Shaft
Bearing