Epson STYLUS PRO 4910 - Page 272

Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 273
Confidential
8. Remove the two screws that secure the tile guide.
A) Silver, Phillips, Round Washer Head S-tite M3x8: two pieces
Figure 3-216. Removing the screws
9. Raise the Mounter so that the Rear Cover comes on the top.
10. While lifting the paper pressing plate slightly, remove the tile guide.
Figure 3-217. Removing the tile guide
A
Tile guide
C A U T I O N
When removing the tile guide, take care in the following.
 Remove the tile guide after raising the Mounter so that the
parts attached to the tile guide do not come off.
 Since the harness is connected to the tile guide, make sure not
to pull it away too far from the main unit.
Tile guide
Paper pressing plate
Rear Cover