Epson Stylus Pro 9500 - Page 32

EPSON Stylus Pro 9500 Revision A
Product Description Control Panel 32
CUTTER REPLACEMENT MENU
The following table includes the steps/messages that must be followed to
replace the cutter.
Each type of setting can be accomplished by operating the following panel
buttons.
o Cutter Replacement Menu Selection: See the panel setting menu
procedure.
o Cutter Replacement: “Paper Source” button
o Changing Setting Values: “+” or “–” button
o Setting the Set Values: “Enter” button
o Mode End: “Pause” button
In this mode, if cutter replacement is carried out, the “Cutter Life” counter in the
print status menu is reset.
Table 1-25. Cutter Replacement Messages
Display Message Item Notes
CUT.REPLACE EXEC. Prepare a replacement cutter and
OPEN LOWER COVER - Open the front cover.
REPLACE CUTTER -
Remove the old cutter and install a
new one.
CLOSE LOWER COVER -
Close the front cover. The printer is
ready.