S
Attach the media holding plates at either side of
the media.
First, position the plates so that the edges of the
media are in the centers of the round holes. Next,
adjust the position until the white line is visible in
the square window and push the plates down to
lock them in place and keep them from lifting.
c
Important:
❏ Do not use the media holding plates with
media that is more than 0.4 mm thick.
The media holding plates could touch
and damage the print head.
❏ Move the media holding plates to the left
and right edges of the platen when they
are not in use.
❏ Do not use the media holding plates if the
sides of the printed media are smudged or
torn.
❏ Leave left and right margins of over 10
mm when using the media holding
plates. Narrower margins could result in
printer printing over the plates (this does
not apply when ink layering is used).
T
Close the front cover.
Using the Optional Heavy Roll Media
Feeding Unit
This section uses the SC-S70600 series to illustrate how
to load media when the optional heavy roll media
feeding unit is installed.
Using a lifter is recommended when handling a media
that is 40 kg or heavier.
The explanation that follows assumes that a lifter is
used.
The following types of lifter can be used.
❏ Fork or platform thickness: 28 mm or less
❏ Fork or platform can be lowered to approx. 190mm
from the floor.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
37
To Next Page
Loading...
