!
Caution:
Because the media is heavy, it should not be carried
by one person. When loading or removing the
media, use at least two persons. Using a lifter is
recommended when handling a media that is 40 kg
or heavier.
A
Turn on the printer by pressing the P button.
c
Important:
When white and metallic silver inks are
installed, maintenance will be performed
automatically to prevent ink accumulating in
the printer and causing clogs. Because turning
the printer off prevents maintenance being
performed, leading to printer malfunction,
we recommend that the printer not be turned
off.
B
Loosen the roll holder fixing screws and adjust
the roll holders so that the gap between the two is
wider than the media.
c
Important:
If the right holder handle shaft is not visible,
rotate the holder forward until it stops. The
media can not be properly loaded if the handle
shaft is not visible.
C
Temporarily place media on the lifter oriented
according to how it is rolled (see below)
Printable Side Out
Printable Side In
Note:
Be sure the option selected for Roll Type in the
Customize Settings menu matches how the media
is rolled. Roll Type defaults to Printable Side Out.
Be sure to select Printable Side In after loading
media rolled printable side in.
For more information see U “Roll Type” on
page 65
D
Place the left edge of the media in any of the black
squares in the label on the bar on the near side of
the back of the printer and the right edge on any
of the holes on the back of the printer.
The recommended positions for media of
different widths are shown below.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
38
To Next Page
Loading...
