52
Setting the power supply unit capacity
Selectable from levels 1 to 3 (Low ∼ High) (initial setting: level 3)
Setting the automatic paper cut
•Not use this function (initial setting)
•Cut paper when the cover is closed
•Print logo when paper is cut
Setting the paper reduction
•Extra upper space reduction: enabled or disabled (initial setting)
•Extra lower space reduction: enabled or disabled (initial setting)
•Line space reduction rate: not reduced (initial setting), 25%, 50%, or 75%
•Line feed reduction rate: not reduced (initial setting), 25%, 50%, or 75%
•Barcode height reduction rate: not reduced (initial setting), 25%, 50%, or 75%
Setting the transmission speed for serial interface
When DIP switches 1-7 and 1-8 are set to ON, the value (initially 38400) can be set to 2400, 4800,
9600, 19200, 38400, 57600, or 115200. (See "Transmission Speed (DIP Switches 1-7/1-8)" on page
40.)
Setting the printer model
When you use the TM-T88V with the APD Ver. 4.00 ~ 4.04, you need to change the printer model
name to “TM-T88IV.”
Printing logo when paper is cut is not available with memory switch setting mode.
To Next Page
Loading...
