Setting Up the Printer 1-17
4. For each roll, insert the tip of the paper into the paper inlet and
push it in until it is automatically detected and fed into the
printer.
5. Tear off the receipt paper on the cutter. If the paper was not fed
far enough, press the
RECEIPT FEED
button to feed additional
paper.
6. Insert the tip of the journal paper into the groove on the take-
up spool and rotate the spool two or three times to secure the
paper. If the paper was not fed far enough, press the
JOURNAL/SLIP FEED
button to feed some additional paper.
7. Install the take-up spool and close the printer cover.
2
2 or 3 times