3. Select Fax on the home screen.
To select an item, use the
u
d
l
r
buttons, and then press the OK button.
4. Pick up the handset.
A connection has been established when the message to press
x
to start sending or receiving a fax is displayed
on the screen.
Related Information
& “Making the Printer Ready to Send and Receive Faxes (Using Fax Setting Wizard)” on page 65
&
“Making Settings to Use an Answering Machine” on page 69
& “Making Settings to Receive Faxes Operating Only a Connected Phone (Remote Receive)” on page 69
& “Setting Receive Mode” on page 67
Making the Printer Ready to Send and Receive Faxes
(Using Fax Setting Wizard)
Fax Setting Wizard congures the basic fax features to make the printer ready to send and receive faxes.
e Wizard is displayed automatically when the printer is turned on for the rst time. You can also display the
wizard manually from the printer's control panel. You need to run the wizard again in case the wizard is skipped
when the printer is
rst
turned on or when the connection environment has changed.
❏ e items below are what you can set through the wizard.
❏ Header (Your Phone Number and Fax Header)
❏ Receive Mode (Auto or Manual)
❏ e items below are set automatically according to the connection environment.
❏ Dial Mode (such as Ton e or Pulse)
❏ Line Type (PSTN or PBX)
❏ Dial Tone Detection
❏ DRD Setting
❏ Other items in Basic Settings remain as they are.
Start Fax Setting Wizard to make Basic Settings, following the on-screen instructions.
User's Guide
Fax Settings
65
To Next Page
Loading...
Need help?
General
