249
Setting Options Description
Line Type PSTN Selects a standard phone line (Public Switched
Telephone Network)
PBX Selects Private Branch Exchange, the type of phone
line used in office environments where an access
code such as 9 must be used to call an outside line
Header Your Phone
Number
Select to enter the header information and your
phone number for inclusion on outgoing faxes
Fax Header
Receive Mode Manual Lets you confirm whether an incoming fax should be
printed; a telephone must be connected to the
product
Auto Automatically receives and prints faxes
Distinctive Ring All If you are using a Distinctive Ring Service on your
phone line, your telephone company can assign two
or more phone numbers to the same line and assign
different ring patterns to each. If you use this service,
select the number of rings for your fax number so
your product can receive faxes on the correct
number of rings. Select All for phones lines that do
not use this service.
Single
Double
Triple
Double&Triple
Rings to Answer 1 to 9 Sets the number of rings before your product
receives a fax. If Receive Mode is set to Auto and an
answering machine is connected to the product,
make sure this setting is set higher than the number
of rings your answering machine is set to answer a
call.
Remote Receive Off Lets you start receiving faxes using your phone
instead of operating the product (if the Receive Mode
is set to Auto). When you select On, you must also
set a Start Code. If you are using a cordless handset
with its base connected to the product, you can start
receiving the fax by entering the code using the
handset.
On
Start Code
To Next Page
Loading...
Need help?
General
