WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision C
Disassembly And Assembly Overview 65
Confidential
4.1.4.1 Protection for Transportation (Securing the Carriage)
Before packing the printer to be returned to the user, attach a piece of strong tape
(length: 250 mm, fold one end: 5 mm) to the carriage to prevent damage during
transportation.
1. Attach the unfolded end of the strong tape on the bottom left of the carriage as
shown in Figure 4-1.
2. Pull the tape and make it adhere to the left side of the carriage.
3. Move the carriage in the direction of the arrow (130 digit side) in Figure 4-1 until
it touches the Carriage Lock.
4. Pull the tape toward the right side of the housing and attach it tightly along the
shapes of the housing as shown in Figure 4-1 to secure the carriage.
Figure 4-1. Securing the Carriage
4.1.5 Locking/Releasing the Carriage
Locking and releasing the Carriage is shown below.
1. Remove the Decoration Plate Right.
(Refer to 4.2.6 Decoration Plate Left/Right
(p.71).)
2. Insert a phillips screwdriver into the hole on the right side of the frame, and rotate
the white shaft of the Ink System Unit.
Figure 4-2. Release the Carriage Lock
Table 4-4. Carriage Lock/Release
Direction of Rotation Carriage
Clockwise (CW) Locked
Counterclockwise (CCW) Released
To Next Page
Loading...
