Epson WorkForce 1100 - Upper Housing Support Assy

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision C
Disassembly And Assembly Removing the Housings 74
Confidential
4.2.8 Upper Housing Support Assy
1. Remove the Upper Housing / Printer Cover. (p.72)
2. Remove the two C.B.S. M3 x 6 screws and two C.B.P. M3 x 10 screws that secure
the Upper Housing Support Assy, and remove the Upper Housing Support Assy.
Figure 4-19. Removing the Upper Housing Support Assy
A D J U S T M E N T
R E Q U I R E D
After replacing the following parts, be sure to apply G-26 grease to the
area specified for each part.
 Printer Cover Holder Left: Chapter 6 See Figure 6-13 (p.158).
 Printer Cover Holder Right: Chapter 6 See Figure 6-13 (p.158).
Secure the Grounding Plate with one of the C.B.S. M3 x 6 screws
together with the Upper Housing as shown below.
1) C.B.P. M3x10
(6±1 kgf.cm)
1) C.B.P. M3x10
(6±1 kgf.cm)
Upper Housing Support Assy
2) C.B.S. M3x6
(6±1 kgf.cm)