Epson WorkForce 1100 - Page 73

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision C
Disassembly And Assembly Removing the Housings 73
Confidential
REMOVING THE PRINTER COVER
1. Remove the Upper Housing / Printer Cover. (p.72)
2. Remove the two C.B.P. M3 x 8 screws that secure Printer Cover Holder Left/
Right.
Figure 4-17. Removing the Printer Cover Holder Left/Right
3. Remove the Printer Cover Holder Right following the steps below.
3-1. With the Printer Cover open, put the Upper Housing with the rear side up.
3-2. Slide the Printer Cover Holder Right in the direction of the arrow while
lifting it, and remove the Printer Cover Holder Right from the Upper
Housing.
Figure 4-18. Removing the Printer Cover
4. While holding the Printer Cover, remove the Printer Cover Holder Left in the same
manner as Step 3-2, and remove the Printer Cover from the Upper Housing.
Insert the tabs (two each on the left/right) shown in Figure 4-17 into
the holes on the Upper Housing.
Tabs
Tabs
4) C.B.P. M3x8
(6±1 kgf.cm)
4) C.B.P. M3x8
(6±1 kgf.cm)
Upper Housing
Printer Cover Holder Right
Printer Cover Holder Left
C A U T I O N
Be careful not to damage the surface in step 3 and later.
C A U T I O N
When performing the following steps, be careful not to damage the
tabs of the Printer Cover Holder Right.
Printer Cover
Upper Housing
Tab
Printer Cover
Holder Right