Epson WorkForce 1100 - Page 84

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision C
Disassembly And Assembly Disassembling the Printer Mechanism 84
Confidential
11. Disconnect the CSIC FFC from the connector on the CSIC Assy, and remove the
CSIC Assy from the Carriage Unit.
Figure 4-45. Removing the CSIC Assy (5)
12. Remove the three C.B.P. M2.6 x 8 screws that secure the Printhead using the
Phillips Screw Driver, No.1, and vertically lift the Printhead to remove it.
Figure 4-46. Removing the Printhead
13. Peel off the Head FFC from the Printhead.
14. Remove the two Head FFCs from the connectors of the Printhead.
Figure 4-47. Remove the Head FFC
CSIC Assy
CSIC FFC
2 1
3
Printhead
7) C.B.P. M2.6x8
(3±0.5 kgf.cm)
 Confirm that the pad is attached at the position in Figure 4-48.
Figure 4-48. Attaching the Pad
connectors
Head FFCs
Printhead
Double-sided tape
Pad