200
3. Configure any other available protocol settings.
4. Click Next.
5. Click OK.
6. Select and configure services and protocol settings as necessary.
After the protocols restart, the changes are applied.
Protocol Settings
Parent topic: Using Your Product on a Secure Network
Protocol Settings
Protocols
Name Description
Bonjour Bonjour is used to search for devices and AirPrint
iBeacon Enable the iBeacon setting to search for the product from
iBeacon-enabled devices
SLP SLP is used for push-scanning and network searching in
EpsonNet Config
WSD Add WSD devices, or print and scan from the WSD port
LLTD Displays the product on the Windows network map
LLMNR Use name resolution without NetBIOS even if you cannot use
DNS
LPR Print from to the LPR port
RAW(Port9100) Print from the RAW port (Port 9100)
IPP Print over the Internet, including AirPrint
FTP Print over FTP
SNMPv1/v2c Remotely set up and monitor your product
SNMPv3 Remotely set up and monitor your product with the SNMPv3
protocol
To Next Page
Loading...
