Sending Many Pages of a Monochrome Document (Direct Send)
When sending a fax in monochrome, the scanned document is temporarily stored in the printer's memory.
erefore, sending a lot of pages may cause the printer to run out of memory and stop sending the fax. You can
avoid this by enabling the Direct Send feature, however, it takes longer to send the fax because the printer
performs scanning and sending simultaneously. You can use this feature when there is only one recipient.
1.
Place the originals.
2.
Select Fax on the home screen.
To select an item, use the
u
d
l
r
buttons, and then press the OK button.
3.
Specify the recipient.
4.
Select the Fax Settings tab, and then select Direct Send to set this to On.
You can also make settings such as the resolution and the sending method as necessary.
5.
Send the fax.
Related Information
& “Placing Originals” on page 58
& “Sending Faxes Automatically Using the Control Panel” on page 139
& “Fax Settings” on page 147
Sending Faxes in Monochrome at Specied Time of the Day (Send Fax Later)
You can set to send a fax at a specied time. Only monochrome faxes can be sent when the time to send is
specied.
1.
Select Fax on the home screen.
To select an item, use the
u
d
l
r
buttons, and then press the OK button.
2.
Specify the recipient.
“Recipient” on page 147
3.
Select the Fax Settings tab, and then select Send Fax Later.
4.
Select the Send Fax Later eld to set this to On.
5.
Select the Time eld, enter the time you want to send the fax, and then select OK.
6.
Select Done to apply the settings.
You can also make settings such as the resolution and the sending method as necessary.
Faxing
>
Sending Faxes Using the Printer
>
Various Ways of Sending Faxes
142
To Next Page
Loading...
Need help?
General
