3.
Select Fax on the home screen.
To select an item, use the
u
d
l
r
buttons, and then press the OK button.
4.
Pick up the handset.
If a message to start sending or receiving faxes is displayed as shown on the following screen, the connection
has been established.
Related Information
& “Making the Printer Ready to Send and Receive Faxes (Using Fax Setting Wizard)” on page 77
& “Making Settings to Use an Answering Machine” on page 81
& “Making Settings to Receive Faxes Operating Only a Connected Phone (Remote Receive)” on page 81
& “Setting Receive Mode” on page 79
Making the Printer Ready to Send and Receive Faxes
(Using Fax Setting Wizard)
Fax Setting Wizard
congures
the basic fax features to make the printer ready to send and receive faxes.
e Wizard is displayed automatically when the printer is turned on for the rst time. You can also display the
wizard manually from the printer's control panel. You need to run the wizard again in case the wizard is skipped
when the printer is
rst
turned on or when the connection environment has changed.
❏ e items below are what you can set through the wizard.
❏ Header (Your Phone Number and Fax Header)
❏ Receive Mode (Auto or Manual)
❏ e items below are set automatically according to the connection environment.
❏ Dial Mode (such as Ton e or Pulse)
❏ Line Type (PSTN or PBX)
❏ Dial Tone Detection
❏ Distinctive Ring Detection (DRD) Setting
❏ Other items in Basic Settings remain as they are.
Fax Settings
>
Making the Printer Ready to Send and Receive Faxes (Using Fax Setting Wizard)
77
To Next Page
Loading...
