11.
On the Run Check Fax Connection screen, select Start Checking to run the fax connection check, and when
the screen prompts you to print the check result, select Print.
A report of the check result that shows the connection status is printed.
Note:
❏ If there are any errors reported, follow the instructions on the report to solve them.
❏ If the Select Line Type screen is displayed, select the line type.
- When you are connecting the printer to a PBX phone system or terminal adapter, select PBX.
- When you are connecting the printer to a standard phone line, select PSTN, and then select Do Not Detect on the
Conrmation screen displayed. However, setting this to Do Not Detect may cause the printer to skip the rst digit of
a fax number when dialing and send the fax to the wrong number.
Related Information
& “Connecting the Printer to a Phone Line” on page 75
& “Setting Receive Mode” on page 79
& “Making Settings to Use an Answering Machine” on page 81
& “Making Settings to Receive Faxes Operating Only a Connected Phone (Remote Receive)” on page 81
& “Basic Settings Menu” on page 84
Making Settings Individually for Printer's Fax Features
You ca n
congure
the printer's fax features individually using the printer's control panel.
e
settings made using
Fax Setting Wizard can also be changed. For more details, see the descriptions of the Fax Settings Menu.
Related Information
& “Menu Options for Fax Settings” on page 83
Setting Receive Mode
ere
are two options in Receive Mode for receiving incoming faxes. You can make settings in the menu below.
Settings > General Settings > Fax Settings > Basic Settings > Receive Mode
Receive Mode Use of Phone Line
Manual Mainly for phoning, but also for faxing
Auto Only for faxing (external phone device is not required)
Mainly for faxing, and sometimes phoning
Related Information
& “Usage of Manual Mode” on page 80
& “Usage of Auto Mode” on page 80
& “Basic Settings Menu” on page 84
Fax Settings
>
Making Settings Individually for Printer's Fax Features
>
Setting Receive Mode
79