LBI-39039B ADMINISTRATION AND EXAMPLE PROGRAMMING
22
LCR
Number
EDACS 7
Private Network 8
Public Network 9
Please refer to Table 1 for the EDACS number plan.
5.2. SCRIPT FILE
The following script file is meant to be a basis for configuring the MD110. This script file must be customized for your
application (by adding board IDs, for example). FIOL can send a completed script file to a LIM with a clean software
load (no configuration).
After the file is sent and a dump (save) to the MD110's Hard Drive Unit (HDU) is performed, the script file can not be
used to change the configuration. If the dump has not been performed, a power cycle of the MD110 will clear the
configuration from RAM and another updated script file can be sent.
Once the MD110 configuration has been dumped (saved), MD110 commands must be entered to end (erase)
configuration information and initiate (enter) configuration. These commands are order-sensitive and require the use of the
MD110 Operation and Maintenance ACS, MD110 Operation and Maintenance SES, Documents for Applications Systems
"Whatever Country," and Least-Cost Routing manuals.
Configuring the MD110 is not recommended for someone with no PBX configuration experience or MD110 training.
The recommended training includes an MD110 Introduction, Extension Programming, Trunk Programming, and Traffic
Management courses. Ericsson provides condensed manuals to attendees of these training courses.
In the script file below, lines requiring user editing are in bold.
/*********************************************************************************/
/* Description: JESSICA MD110 Configuration Script File */
/* File Name: JESS_MD.TXT */
/* Version: 0.02 */
/* Date: 10-December-93 */
/*********************************************************************************/
/*********************************************************************************/
/* NUMBER ANALYSIS */
/*********************************************************************************/
/*********************************************************************************/
/* Least Cost Routing */
/*********************************************************************************/
NANSI:NUMTYP=LC, NUMSE=9;
/*********************************************************************************/
/* External Destination */
/*********************************************************************************/
NANSI:NUMTYP=ED, NUMSE=0&&3&670&&699;
NOTE
To Next Page
Loading...
