EU DECLARATION OF CONFORMITY
According to
The Low Voltage Directive 2014/35/EU, entering into force 20 April 2016
The EMC Directive 2014/30/EU, entering into force 20 April 2016
The RoHS Directive 2011/65/EU, entering into force 2 January 2013
Type of equipment
PLASMA CUTTING SYSTEM
Type designation etc.
CutMaster 40, from serial number 007-XXXXXX
Brand name or trade mark
ESAB
Manufacturer or his authorised representave
Name, address, telephone No:
OZAS-ESAB Ltd.
ul. A. Struga 10,
45-073 Opole, Poland
Phone: +48 77 4019270, FAX + 48 77 4019 201.
The following harmonised standard in force within the EEA has been used in the design:
IEC/EN 60974-1:2017 / AMD1:2019 Arc Welding Equipment - Part 1: Welding power sources.
IEC/EN 60974-10:2014 + AMD 1:2015 Published 2015-06-19 Arc Welding Equipment - Part 10: Electro-
magnetic compatibility (EMC) requirements
Additional Information: Restrictive use, Class A equipment, intended for use in location other than
residential.
By signing this document, the undersigned declares as manufacturer, or the manufactur-
er’s authorised representative , that the equipment in question complies with the safety
requirements stated above.
Date Signature Position
10 February, 2020
Flavio Santos General Manager
Accessories and
Adjacencies
2020
To Next Page
Loading...
