ESAB FABRICATOR 141i
INTRODUCTION 2-2 Manual 0-5420
2.05 Transportation Methods
!
WARNING
Disconnect input power conductors from de-energized supply line before moving the
welding Power Source.
Lift Power Source with handle on top of case. Use handcart or similar device of adequate
capacity. If using a fork lift vehicle, secure the Power Source on a proper skid before
transporting.
2.06 User Responsibility
This equipment will perform as per the information contained herein when installed, operated, maintained and repaired in ac-
cordance with the instructions provided. This equipment must be checked periodically. Defective equipment (including welding
leads) should not be used. Parts that are broken, missing, plainly worn, distorted or contaminated, should be replaced immediately.
Should such repairs or replacements become necessary, it is recommended that such repairs be carried out by appropriately quali-
fied persons approved by ESAB. Advice in this regard can be obtained by contacting an Accredited ESAB Distributor.
This equipment or any of its parts should not be altered from standard specification without prior written approval of ESAB. The
user of this equipment shall have the sole responsibility for any malfunction which results from improper use or unauthorized
modification from standard specification, faulty maintenance, damage or improper repair by anyone other than appropriately quali-
fied persons approved by ESAB.
2.07 Fabricator 141i Portable System Package (Part No. W1003141)
Comes Complete With:
•
Fabricator 141i Power Source
• 140 Amp MIG Gun
• Regulator/Flowmeter & Hose
• ESAB Electrode Holder & Ground Clamp
• Drive Rolls & Contact Tips
• Sample Electrodes & Shoulder Strap
• 20A to 15A Power Cord Adapter
• Operator Manual & CD
A-12917
To Next Page
Loading...
Need help?
General
